Acura Series Measuring System Pinchweld Stands USERS MANUAL

Honda Universal Adapter (Accord & Acura Series) For: • Universal Anchoring System • Universal Measuring System Pinchweld Stands USERS MANUAL Part No. 150085 2006 © Chief Automotive Technologies, Inc. Chief’s Limited One-Year CHIEF'S LIMITED ONE-YEAR WARRANTY & LIABILITY Chief Automotive Technologies, Inc. warrants for one year from date of installation and/or purchase any of its products which do not perform satisfactorily due to defect caused by faulty material or workmanship. Chief’s obligation under this warranty is limited to the repair or replacement of products which are defective and which have not been misused, carelessly handled, or defaced by repair or repairs made or attempted by others. CHIEF AUTOMOTIVE TECHNOLOGIES, INC. DOES NOT ASSUME RESPONSIBILITY FOR ANY DEATH, INJURY OR PROPERTY DAMAGE RESULTING FROM THE OPERATOR’S NEGLIGENCE OR MISUSE OF THIS PRODUCT OR ITS ATTACHMENTS. CHIEF MAKES NO WRITTEN, EXPRESS OR IMPLIED WARRANTY WHATSOEVER OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR OTHERWISE REGARDING THE EQUIPMENT OR ANY PART OF THE PRODUCT OTHER THAN THE LIMITED ONE-YEAR WARRANTY STATED ABOVE. HONDA UNIVERSAL ADAPTER ACCORD AND ACURA SERIES Specially designed adapters are used in conjunction with Universal Anchoring System (UAS) stands and Universal Measuring System (UMS) pinchweld stands when securing vehicles with horizontal pinchwelds and vertical jack tabs in the corners of their center sections. (All Honda / Accord / Acura vehicles excluding Odessey.) These adapters allow the positioning of vertical jack tabs into a slot on the adapter’s top surface, and the attachment of 4 inch clamps to horizontal pinchwelds. The Honda adapters attach to UAS stands in two ways dependent upon anchoring tube used. Figure 1 shows attachment to the ears of a UAS clamp bar tube. Figure 2 shows attachment to the vertical surface of a UMS adapter tube. Figure 3 shows attachment to the vertical surface of a UMS pinchweld stand. Each illustration shows the Honda adapter in its lowest mounted position. IMPORTANT: Information on use of anchoring stands (including their attachment to repair system mainframes) appears in the UAS Users Manual and UMS Pinchweld Stand Users Manual.

Spacers are provide with Honda adapters which allow height adjustment of horizontal clamps. The spacers, positioned between top surface of adapter and bottom surface of lower clamp half, are provided in these thicknesses: 1/8” (3.17mm), 1/4” (6.35mm), 1/2” (12.7mm), and 1“ (25.4mm). This manual identifies the correct spacer(s) to use for each Honda / Accord / Acura vehicle. (See following pages.) Use the identified spacer(s) regardless of the anchoring setup and observe the following when applicable.

>>>Get The File | Download here | PDF Manual