Honda Universal
Adapter
(Accord & Acura Series)
For: • Universal Anchoring System
• Universal Measuring System
Pinchweld Stands
USERS MANUAL
Part No. 150085
2006 © Chief Automotive Technologies, Inc.
Chief’s Limited One-Year
CHIEF'S LIMITED ONE-YEAR
WARRANTY & LIABILITY
Chief Automotive Technologies, Inc. warrants for one year from date of installation
and/or purchase any of its products which do not perform satisfactorily due to defect
caused by faulty material or workmanship. Chief’s obligation under this warranty is
limited to the repair or replacement of products which are defective and which have not
been misused, carelessly handled, or defaced by repair or repairs made or attempted by
others.
CHIEF AUTOMOTIVE TECHNOLOGIES, INC. DOES NOT ASSUME
RESPONSIBILITY FOR ANY DEATH, INJURY OR PROPERTY DAMAGE
RESULTING FROM THE OPERATOR’S NEGLIGENCE OR MISUSE OF THIS
PRODUCT OR ITS ATTACHMENTS. CHIEF MAKES NO WRITTEN,
EXPRESS OR IMPLIED WARRANTY WHATSOEVER OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR OTHERWISE
REGARDING THE EQUIPMENT OR ANY PART OF THE PRODUCT OTHER
THAN THE LIMITED ONE-YEAR WARRANTY STATED ABOVE.
HONDA UNIVERSAL ADAPTER
ACCORD AND ACURA SERIES
Specially designed adapters are used in conjunction with Universal Anchoring System (UAS)
stands and Universal Measuring System (UMS)
pinchweld stands when securing vehicles with horizontal pinchwelds and vertical jack tabs in the corners of their center sections. (All Honda / Accord /
Acura vehicles excluding Odessey.) These
adapters allow the positioning of vertical jack tabs
into a slot on the adapter’s top surface, and the
attachment of 4 inch clamps to horizontal pinchwelds.
The Honda adapters attach to UAS stands in two
ways dependent upon anchoring tube used.
Figure 1 shows attachment to the ears of a UAS
clamp bar tube. Figure 2 shows attachment to the
vertical surface of a UMS adapter tube. Figure 3
shows attachment to the vertical surface of a UMS
pinchweld stand. Each illustration shows the
Honda adapter in its lowest mounted position.
IMPORTANT: Information on use of anchoring stands (including their attachment to repair
system mainframes) appears in the UAS Users
Manual and UMS Pinchweld Stand Users
Manual.
Spacers are provide with Honda adapters which
allow height adjustment of horizontal clamps. The
spacers, positioned between top surface of
adapter and bottom surface of lower clamp half,
are provided in these thicknesses: 1/8” (3.17mm),
1/4” (6.35mm), 1/2” (12.7mm), and 1“ (25.4mm).
This manual identifies the correct spacer(s) to use
for each Honda / Accord / Acura vehicle. (See following pages.) Use the identified spacer(s) regardless of the anchoring setup and observe the following when applicable.
>>>Get The File | Download here | PDF Manual
